Using Monitor Our - Sony Trinitron KV-27S22 Operating Instructions Manual

Connecting two VCRs for tape
°editing using MONITOR OUT
"_ KV-27V22, 29V22M only
MONITOR OUT gives you the ability to use a
second VCR to record a program being played
by the primary VCR or to perform tape
editing and dubbing.
1 Connect the VCR intended for playback
using the setup instructions on page 3 of
this manual.
2
Using AUDIO/VIDEO connectors,
connect AUDIO and VIDEO IN on your
VCR intended for recording to MONITOR
AUDIO and VIDEO OUT on your TV.
Notes:
• Do not change the input signal while
editing through MONITOR OUT.
• When connecting a single VCR to the TV; if
VCR LINE OUT is connected to TV VIDEO
IN, do not connect the TV MONITOR OUT
jacks to the VCR LINE INPUT (see right).
Doing so will cause program interference
and other viewing problems.
Disconnect all power sources before making any connections.
(Rear of TV)
VCR (fo_ Pl0ayback! __ _ _oVCRL(for recordinq)
1 _ _/_ _/_ 2 _V,DEO(ye,ow)
AUDIO-/(white)
AUDIO-R (red)
i l
VMC-810S/820S (not supplied) VMC-810S/820S (not supplied)
Indicates direction
of signal