Connecting Two Vcrs For Tape Editing Using Monitor Out - Sony Trinitron KV-27S26 Operating Instructions Manual

HIM? Connecting and Installing the TV (continued)
Connecting two VCRs for tape
editing using MONITOR OUT
e KV-27V26, 27V36, 29V36C, 29V66M, 29V76M,
32V26, 32V36, 34V36C, 35V36, 35V76, 37V36M only
MONITOR OUT gives you the ability to use a
second VCR to record a program being played
by the primary VCR or to perform tape
editing and dubbing.
1 Connect the VCR intended for playback
using the setup instructions on page 4 of
this manual.
2 Using AUDIO/VIDEO connectors,
connect AUDIO and VIDEO IN on your
VCR intended for recording to MONITOR
AUDIO and VIDEO OUT on your TV.
Notes:
¢ Do not change the input signal while
editing through MONITOR OUT.
e When connecting a single VCR to the TV;
if VCR LINE OUT is connected to TV
VIDEO IN, do not connect the TV
MONITOR OUT jacks to the VCR LINE
INPUT (see right). Doing so will cause
program interference and other viewing
problems.
Disconnect all power sources before making any connection:
(Rear of TV)
Q
È
VCR (for playback) VCR (for recording)
VIDEO (yellow)
AUDIO-I (white)
AUDIO-R (red)
AUDIO R_AUDIO L_ VIDEO
Lt ol
VMC-810S/8205 (not supplied) VMC-810S/8205S (not supplied)
(Rear of TV)
indicates direction
of signal