Pinegreen Lighting CL-RUH24 Quick Start Manual

ITEM#CL-RUH24 | 2,400 Lumens LED Rechargeable Under Hood Worklight
Before your first use, do please charge and discharge the batteries
Recharging:
• Completely charge the batteries before your first use the lamp.
• The lamp must be charged per three months to protect the battery lifetime.
Charging using an 5V DC USB charger (not included):
• Plug the power supply into USB main charger
• Plug the charger cable into the USB Micro socket .
• External charging port for phone and etc.
• The battery charging status can be determined by reading the battery status. If all 4LEDs are lit , the battery
is fully charged.
• Type-C charging port.
Usage:
The on-off switch
• Press one time : Main LED 50%
• Press second time : Main LED 100%
• Press third time : OFF
Diagram:
1. Telescopic bracket
2. Bracket fixing seat
3. Shockproof circle
4. Aluminum tube fixing sleeve
5. Aluminum Tube
6. Damping Rotor
7. Single lamp
• Do not look directly at the LED lights for any length of time.
• Do not remove protective lens covering LED lights.
This product is guaranteed against failure due to factory defects in materials or workmanship for two
(2) year from the date of purchase. This warranty is non-transferable and applies only to the original
owner. Proof of purchase required for repair or replacement. This warranty does not cover normal
wear of parts or damage resulting from any misuse of the product. Misuse of the product includes
but is not limited to: using in extreme weather conditions, opening the housing of the product, or
attempted remodel/alterations made to product.
Question/Comment/Missing Part?: Contact 1-888-745-4837
ITEM#CL-RUH24 | 2,400 Lumens LED Rechargeable Under Hood Worklight
• When using this product, basic precautions should always be followed.
• Read and follow these instructions and observe all warnings.
• Carefully read and understand the information given in this manual before
beginning installation. Failure to do so could lead to electric shock, fire, or other
injuries which could be hazardous or even fatal.
• Save these instructions and warnings.
This product may present a possible shock or fire hazard if improperly
installed or mounted. Products should be installed following these instructions,
local electrical codes, and the current National Electric Code (NEC).
• Do not use the lamp in the immediate vicinity of inflammable materials or gases.
• Make sure that the illuminants are not covered during use.
• Only use the accessories included with the product for recharging your
rechargeable workshop lamp.
• Keep the lamp out of reach of unauthorised persons, especially children.
• Do not point the light directly in your own or any other person's or animal's eyes.
• Always check the mains cable before you use the charger. If the mains cable is
damaged, replace the charger.
• Do not dispose of used batteries with domestic waste, but leave them at an
appropriate collection point for disposal.
Question/Comment/Missing Part?: Contact 1-888-745-4837
WARNING:
TO AVOID RISK OF ELECTRICAL SHOCK, TURN
OFF OR DISCONNECT FROM POWER WHILE
INSTALLING OR SERVICING UNIT.