MASSEY FERGUSON MF 7345 S Workshop Service Manual page 13

2. General Information - 00
• machine model (commercial name) and frame number;
• combine type and number;
• part number of the ordered part, which can be found in the "Spare Part Catalog" , used for order
processing.
Notes on tools
The tools that AGCO suggests and describes in this manual:
• have been expressly studied and designed to operate on the AGCO range of combine harvesters;
• are required to get a reliable repair;
• are suitably manufactured and strictly tested to offer efficient and long-lasting work tools.
By using these tools, Repair Personnel will benefit from:
• working under the best technical conditions;
• getting the best results;
• saving time and effort;
• working more safely.
Notes
Wear limit values indicated for certain parts should be considered as recommended values, but not
absolutely mandatory. The directions front, rear, right and left referring to different parts are given from the
viewpoint of the operator sitting in the driver's seat and facing the same direction as the combine moving
forward.
How to move the combine without battery
The cables of the external power supply unit must be connected only to the respective negative and
positive cable terminals of the combine using pliers in good working order that will ensure proper and
stable contact.
Disconnect all circuits (lights, windscreen wipers etc.) before starting the combine.
If functional checks need to be run on the combine's electrical system, only proceed after connecting the
power supply unit. At the end of the checks, disconnect all the circuits and switch the power supply off
before disconnecting the cables.
2-4 Combines
LA327325014M_7345S_7347S_EN