Table of Contents
Advertisement
INSTALLATION
|
1. This appliance is designed to operate in ambient
temperatures
between
10°С (50°F) and 32°С
(90°F). It should be located in a dry atmosphere,
out of direct sunlight and away from extreme
temperature e.g. not next to a cooker or other
sources of direct heat, or in a very cold room e.g.
an outhouse, where the temperatures may fall
below 10°С (50°F).
2. The appliance should be gently pushed into
place until the table top rear ventilation grill touches
the wall, see Fig 1.
When in position a 20mm (3/4") clear space above
the appliance should be maintained. If a clear
space of 20mm (3/4") above the appliance is not
available clearances of 25mm (1") should be
maintained on both sides of the appliance, this is to
provide sufficient air circulation. Always ensure that
the ventilation is kept clear from blockage by
teatowels
etc., because
this will cause
the
appliance to work incorrectly.
3. Your appliance will be heavy when loaded with
food and must therefore be stood on a strong firm
floor which should also be level. Adjust the level by
screwing out the appropriate level adjusters in the
feet using your fingers or a suitable spanner (see
fig. 2).
Make
sure the appliance
is upright and all
adjusters are in firm contact with the floor, so that
the cabinet doesn't rock in any direction.
4. Before switching on, make sure that the voltage
of your electricity supply is the same
as that
indicated on the rating plate. This is located inside
the cabinet behind the salad drawer.
5. Remove ALL the foam blocks from the front of
each basket, by pinching the block at its base and
peeling back. These must be removed before
operating the appliance.
DOOR REVERSAL
|
1. If your appliance is already in use, disconnect it
from the electricity supply and remove shelves and
other loose items, including food. Place frozen food
in boxes wrapped in blankets or other suitable
insulating material and put in a соо! place.
2. Gently lay the appliance on its back with the top
held away from the floor by at least 30cm (12"),
use a stool or something similar. Make sure to use
a towel or cloth at the base to protect the sides of
the appliance ensuring that it does not slip. Do not
support the appliance on the rear ventilation grill,
see Fig. 3.
3. Remove level adjuster (1) from the small foot
assembly. The small foot (2) can now be removed
by removing screw (3). In order to remove the large
foot/hinge assembly (7) screws (4, 5 & 15) should
be removed making sure that spacer (6) is retained
with the assembly, see Fig. 4.
Carefully disengage the door from the upper hinge
pin (See Fig. 5).
Unscrew the upper hinge pin (9) and transfer it to
the opposite side (See Fig. 5).
4. Refit the door, engaging the top with the upper
hinge pin in its new position.
5. Pull out the lower hinge pin (8) which may have
come
away with the hinge blade or remained in
the door. Push the pin (rounded end) into the bush
at the bottom of the door on the side opposite to its
origina! position.
6. Taking care not to press-down on the door. The
large foot/hinge assembly should be transferred
over to the opposite side of the cabinet and
screws, 15, 4 and 5 moved over to their new
positions in the hinge foot.
7. It is important that the spacer (6) is retained with
screw (4) in the channel between the base of the
appliance arid the foot/hinge when screwing the
assembly into its new position.
8. Refit the small foot, positioning the screw in the
hole furthest from the cabinet front on the flat
portion of the base.
9. Replace the level adjuster (1) in the small foot.
10. Stand the appliance upright.
11. If your appliance has a side fix handle, see Fig
6.
i) Protect the paintwork from damage with
masking tape or other suitable material
between the blade and painted. surface, while
using a blunt knife or similar instrument to
carefully prise out the plastic plugs from
alternative handle positions on the opposite
side of the door.
ii) Transfer the handle to its new position and
push the plastic plugs into the vacated screw
holes.
12. Finally level the appliance by means of the
level adjusters (1) in the feet.
Advertisement
Table of Contents
