This instruction book contains safety precautions, information on use and helpful hints and tips. To ensure you use this appliance effectively and safely, please read this instruction book carefully before installing or using this appliance and retain for future reference. The symbols below help you to find things more easily: Safety precautions Warnings and Safety information...
IMPOR ANT S AFET Y INS UCTIONS IMPOR ANT S AFET Y INS UCTIONS These warnings are provided in the interests of your safety. Ensure that you understand them all before installing or using this appliance. Your safety is of paramount importance. If you are unsure about any of the meanings or these warnings contact the Customer Care Department.
ONTENT ONTENT Instructions for the User Instructions for the Installer Guide to use the instruction book Technical data Important Safety Information Installing the Appliance Transportation, Unpacking Location Instructions for the User Ventilation Requirements General Information Levelling Description of the Appliance Door Reversal Indicator Lights Fast Freeze Facility...
UCTIONS F OR THE USER UCTIONS F OR THE USER General information To ensure correct operation, the appliance should be located where the ambient temperature is between 16-32 °C. This appliance is designed for the freezing and storage of frozen food in a domestic home. Description of the Appliance 1.
Indicator Lights The indicator lights are situated in the control panel. A.)Green Indicator Light When the appliance is switched on at the mains the green indicator light will glow and continue to glow until the appliance is switched off at the mains. B.)Red Indicator Light A few hours after starting up this will go out to show that the correct temperature has been reached for...
Using the Appliance Before Use Remove all packaging and securing tapes. Wash inside the appliance with lukewarm water and bicarbonate of soda (5 ml to 0,5 litre of water). Do not use soap or detergent as the smell may linger. Dry thoroughly.
3. Then push the fast freezer switch again (the yellow light will go out and the switch turns to its original To Make Ice Cubes position). 1. Fill the ice cube tray 3/4 full with cold water, 4. The freezing tray is suitable for freezing smaller place in the freezing compartment and leave to fruits (raspberry, strawberry, currant, etc.).
Energy Saving Advice In the Event of a Power Failure Do not install the appliance close to sources of If there is a power failure during the storage of heat, such as a boiler or radiator. frozen foods, keep the door closed. If the temperature within your freezer should rise, do not Locate the appliance in a cool well ventilated room refreeze the food without checking its condition.
5. During defrosting, push the defrost water To carry out complete defrosting: towards the edge of the cooling plates using a dry cloth or a sponge. It will be collected at the 1. Disconnect the appliance from the electrical bottom of the appliance, from where it can be supply.
vice and Spar vice and Spar For Customer Service in Ireland please contact us at the address below: Electrolux Group (Irl) Ltd Long Mile Road Dublin 12 Republic of Ireland Tel.: +353 (0) 1 4090753 Email: service.eid@electrolux.ie When you contact the Service Centre you will need to give the following details: 1.
Ins aller uctions f or the Ins aller Technical data Model TFT 12 JA Gross capacity (l) Net capacity (l) Width (mm) Height (mm) Depth (mm) Energy consumption (kWh/day) 0,77 (kWh/year) Energy class, according to EU Standards...
Ventilation Requirements The appliance must have adequate ventilation to ensure correct operation. Diagram shows the ventilation requirements when installed: A* Under a worktop, or cupboard. * The clearance space of 10 cm above the appliance may be reduced to 5 cm providing a clearance space 2.5 cm is left on either side of the appliance.
Page 14
Fit the door in place on the hinge pin. Refit the bottom hinge plate assembly on the opposite side, taking care that the edge of the door is parallel with the side of the cabinet. Slot the hinge pin into the hole in the hinge plate and relocate the hinge assembly to the opposite location and refit using the retaining screws.
Electrical Connection Electrical Connection Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. This appliance must be earthed. The manufacturer declines any liability should these safety measures not be observed. Electrical Requirements Before switching on, make sure the electricity supply voltage is the same as that indicated on the appliance...