Adjusting The Programme Settings; Loading Laundry; Adding Detergent And Care Product; Starting The Programme - Bosch WGB254A0SG User Manual And Installation Instructions

Table of Contents

Advertisement

13.3 Adjusting the pro-
gramme settings
Requirement: A programme has
been set.
→ "Setting a programme", Page 32
Adjust the programme settings.
→ "Buttons", Page 24
Observe the information about op-
erating logic → Page 18.
Notes
¡ The programme settings are not
saved permanently for the pro-
gramme.
¡ The setting is saved if you activate
or deactivate the intelligent dosing
system.
13.4 Loading laundry
Note: To prevent creasing, note the
maximum load for the programmes.
→ "Programmes", Page 27
Requirements
¡ The laundry is prepared and sor-
ted.
→ "Laundry", Page 31
¡ The drum is empty.
Open the door.
1.
Place the laundry in the drum.
2.
Close the door.
3.
Ensure that there is no laundry
trapped in the door.
13.5 Adding detergent and
care product
For programmes in which intelligent
dosing is not possible or desirable,
you can add detergent manually.
Tip: In addition to intelligent dosing,
you can also add additional care
product for laundry, e.g. stain re-
mover, starch or bleach, to the
manual dosing compartment. Do not
add any additional detergent to the
manual dosing compartment to avoid
overdosage and/or foaming.
Note: Observe the information about
detergents and care products
→ Page 31.
Pull out the detergent drawer.
1.
Pour in detergent.
2.
→ "Detergent drawer", Page 17
If required, add the care product.
3.
Push in the detergent drawer.
4.
13.6 Starting the programme
Requirement: A programme is set.
→ "Setting a programme", Page 32
Press
.
a The drum rotates and load detec-
tion takes place. This can take up
to 2 minutes, after which water
enters the drum.
a The display shows the programme
duration or the programme end
time.
a After the programme has ended,
the display shows: End.
13.7 Soaking laundry
Note: No additional detergent is re-
quired for soaking. The appliance
uses the filled detergent for soaking
and washing.
Requirements
¡ The laundry is placed in the appli-
ance.
→ "Loading laundry", Page 33
¡ A programme has started.
→ "Starting the programme",
Page 33
Press
approx. 10 minutes after
1.
the programme start.
The programme pauses and the
laundry can soak.
Press
after the required soak-
2.
ing time.
Basic operation en
33

Advertisement

Table of Contents
loading

Table of Contents