Table of Contents
Advertisement
en Fault, what to do?
Remove any residue and clean
4.
filters under running water.
Re-install filter system in reverse
5.
sequence and ensure that the arrow
marks are opposite each other after
closing the filter system.
Spray arms
Limescale and contaminants in the
rinsing water may block nozzles and
bearings on the spray arms 1: and
1J.
Check outlet nozzles on the spray
1.
arms for blockages.
Unscrew the upper spray arm 1:
2.
(1) and remove downwards (2).
Remove the lower spray arm 1J
3.
upwards.
Clean spray arms under running
4.
water.
Re-engage or screw on spray arms.
5.
34
3
Fault, what to do?
E xperience has shown that you can
F a u l t , w h a t t o d o ?
rectify most faults which occur in daily
operation yourself. This ensures that the
appliance is quickly available to you
again. In the following overview you can
find possible causes of malfunctions
and helpful information for rectifying
them.
If the appliance stops during
Note:
dishwashing or does not start for no
obvious reason, first run the Abort
programme function (Reset)
~ "Operating the appliance"
on page 28.
:
Warning
Improper
repairs or use of non-original spare
parts may cause considerable damage
and put the user at considerable risk!
Always have repairs carried out by
technicians. If a component has to be
replaced, always use original spare
parts.
Advertisement
Table of Contents
