To Thread The Bobbin Case; To Replace The Bobbin Case - Singer 15-91 Instructions For Using Manual

14
Fie. 9. ApsustMENT or Bopsrn WINDER
15 16
TO THREAD THE BOBBIN CASE TO REPLACE THE BOBBIN CASE
Hold the bobbin case by the latch and place it
unwind in the
direction
shown in
Fig. 10,
race,
bobbin Hold the
case as shown in
Fig. 10, and place
the bobbin into it.
Fie. 13. Bossrn Case THREADED AND RepLaceD
Release the latch and press the bobbin case back
until the latch enters the groove in the stud. Allow
Pull the thread into
the slot 1, under the
i o n spri ] £19009
jefe the not 4 f ne about three inches of thread to hang free from the
end of the spring. Brats bobbin case and close the bed slide plate.