Page 1
2-4 M INTRODUCTION & WARRANTY Thank you for selecting and buying V-TAC product. V-TAC will serve you the best. Please read these instructions carefully before starting the installation and keep this manual handy for future reference. If you have any another query, please contact our dealer or local vendor from whom you have purchased the product.
Page 2
WARNING 1. Please make sure to turn off the power before starting the installation. 2. Installation should be done by certified electrician. . 3 The light source of this luminaire is not replaceable; when the light source reaches its end of life the whole luminaire shall be replaced. This marking indicates that this product should not be disposed of with other household wastes.
Page 3
2 OPTIONAL WORKING MODES Mode A: Sensor Mode Press the button 1st time, the back light flashes once, it’s Sensor Mode: When battery power is greater than 30%: Lamp automatically lights up at night and turns to full brightness when motion is de- tected within the range of ≤6mtrs, then dims to lower brightness(front light and back light both on) after 20 seconds of no motion.
Page 4
BATTERY REPLACEMENT Loosen the screws, open battery cover. 2. Remove old battery, change new battery and connect positive and negative electrode correctly. (18650, 3.7V, 2000mAh, 7.4Wh) 3. Then install back the cover, lock the screws. MAINTENANCE & WARNING • Do not use solvents, petrol, etc. Otherwise the light will be damaged. •...
Need help?
Do you have a question about the VT-768 and is the answer not in the manual?
Questions and answers