Autoprogram - Hitachi 13GA1B Operating Manual

AUTOPROGRAM
AUTOPROGRAM stores in memory only the active channels available in your area.
For example, to set the channels by AUTOPROGRAM.
1). Press the MENU button.
2). Select "SET UP" by pressing the MENU SELECT UP/DOWN
(A/V) buttons or the CHANNEL NUMBER button "1".
(Fig. 1)
3). Press the ENTER button.
4). Select "INITIAL SETTING" by pressing the MENU SELECT UP/
DOWN (_kiV) button or the CHANNEL NUMBER button "2".
(Fig. 2)
5). Press the ENTER button.
6). Select "AUTOPROGRAM" by pressing the MENU SELECT UP/
DOWN (A/V) button or the CHANNEL NUMBER button "2".
(Fig. 3)
7). Press the ENTER button.
MENU
r i
J i ,1. SET UP,
• ......... J
2. PICTURE
PRESS ENTER TO SET
Fig. 1
SET UP
I. CLOSED CAPTION
r •
12. INITIAL SETTING'+
3. CHILD LOCK
Fig. 2
INITIAL SETTING
1. AIR/CABLE
t2. AUTOPROGR AM',
3. CHANNEL MEMORY
8). Press the MENU SELECT RIGHT (•) button to begin autopro
grarnming. (Fig. 4,5)
The TV will cycle through the channels available in your area
and store them in memory.
When autoprogramming is completed, the lowest cha0nel hum
her of the channels stored in memory is displayed and the TV re-
turns to the normal mode.
i
Note : If the MENU button .is pressed during program_, the pro-
t
gramming will stop.
Fig. 3
I AUTOPROGRAM
PRESS • TO BEGIN
Fig. 4
CHANNEL ',1 2;
L_ •
NOW AUTOPROGRAM
IS IN PROGRESS
Channel number is displayed during
scanning AIR mode: 02 _ 69, CATV
mede : 01"_..125
Fig+ 5
1
L
®