Service, Optical Device(7G), Cable, Flexible Flat - Sony SHAKE-99D Service Manual

HCD-SHAKE99/HCDSHAKE100
Ver. 1.1
2-9.

SERVICE, OPTICAL DEVICE(7G), CABLE, FLEXIBLE FLAT

Note 1 : Before disconnecting the cable, fl exible fl at (24 core) of optical pick-up block, solder the short-land.
1 six claws
8 four insulator screws
qs service,
optical device(7G)
qa insulator
6 belt
3 Insert the thin
wire (clip etc.).
4
Note: This illustration sees the loading assy (T) from bottom side.
1 cable, flexible flat (24 core)
loading assy (T)
terminal face
2 Through the hole
14
2 chuck holder assy (T)
qa insulator
0
9
7 connector
qd base, lo assy
5 tray
5 two claws
3 Through the hole
Under the guide
(Fold area)
2 Solder the short-land.
Note 2: When assembling the optical
qg tape
qf wire (flat type)
(5 core)
qa insulator
qh
– Bottom view –
5 three claws
6 holder, FFC
4
7 cable, flexible flat
Under the guide
pick-up block, remove the solder of
short-land after connecting the
cable, flexible flat (24 core).
qj holder, FFC
qk cable, flexible flat
(24 core)
loading assy (T)
(24 core)
9 tape
8 wire (flat type)
(5 core)