Cutting Height Adjustments; Single Lever - Troy-Bilt TB200 Operator's Manual

Cutting Height Adjustments

This mower is equipped with one of three types of cutting height
adjustment. Refer to Single Lever, Dual Lever or Rear Wheel/
Caster Wheels in this section.

SINGLE LEVER

The single lever cutting height adjustment is located above the
rear left wheel (Figure 22).
1. Carefully pull the height adjustment lever outward towards
wheel (mower will tend to fall when lever is moved outward).
2. Move lever to desired position for a change in cutting height.
3. Release lever towards deck.
Figure 22
DUAL LEVER
Front Wheel Drive Mowers - The dual lever cutting height
adjustment levers are located above the front and rear right
wheels.
Rear Wheel Drive Mowers - The dual lever cutting height
adjustment levers are located above the front and rear left
wheels.
NOTE: Front wheel drive mower shown in Figure 23.
NOTE: On select mowers - The front and rear height adjustment
levers move in the opposite direction to adjust height.
1. Carefully pull the height adjustment lever outward towards
wheel (mower will tend to fall when lever is moved outward).
2. Move lever to desired position for a change in cutting height.
3. Release lever towards deck.
IMPORTANT: All wheels must be placed in the same position. For
rough or uneven lawns, move each height adjustment lever to a
higher position. This will prevent you from cutting the grass too
close to the ground.
ADJUSTMENTS
2
Lower
Higher
3
Higher
1
3
NOTE: Front wheel
drive mower shown.
REAR WHEEL/CASTER WHEELS
NOTE: The rear wheel cutting height adjustment lever is located
above the rear left wheel (Inset A, Figure 24).
1. Pull lever out and away from mower.
1
2. Move lever forward or back for desired cutting height.
3. Release lever towards mower deck.
NOTE: The caster wheels cutting height are determined by
selecting one of six positions on each caster assembly (Figure 24).
4. Remove wing nut (a) from axle bolt (b). Slide axle bolt from
the assembly and select a cutting height.
5. Reinsert axle bolt in the square hole desired through wheel
assembly and secure with wing nut removed in STEP 1.
IMPORTANT: All wheels must be placed in the same relative
position. For rough or uneven lawns, move the height
adjustment lever to a higher position. This will stop scalping
of grass.
6. The casters can be locked in a straight ahead position or
positioned to swivel freely (Inset B, Figure 24).
a. Lift lock pins.
b. Place in larger holes to lock wheels. Place pins in smaller
holes to allow casters to rotate freely for turning.
2
3
12
Lower
Higher
1
3
Figure 23
A
1
a
a
b
1
Figure 24
2
Lower
b
B
2