Safety Instruction - PROFECO 42250 Instruction Manual

Safety Instruction

Please ensure that you have read and understood the safety precautions described
in the following text before using the product, so that you can operate it correctly. The
safety precautions described in the following text will help you to operate the product
and its accessories correctly and safely to avoid damage and loss to yourself, other
people and the equipment.
Considerations
To avoid damage to the product, please follow the instructions below:
Don't assemble or disassemble the product without permission.
The product is a high precision piece of equipment. Do not attempt to disassemble,
assemble, or modify any part of the product.
Avoid damaging the probe of the product.
Note: Don't place the product directly next to a strong heat source (such as an
electric iron). This may damage the probe of the product.
Product hums.
When the product is working, there is a slight clicking sound every few seconds. This
is a normal phenomenon of the lens taking pictures.
Warning
The warning describes actions that may cause harm to users. Please observe the
following procedure to avoid electric shock or personal injury.
• If the product case is damaged, do not use it continuously.
Please contact your local distributor.
• If, during use, you notice smoke, sparks or a burnt smell sparks or a
burnt smell, stop using the product immediately.
If this happens, the first thing to do is to switch off the power supply to the
product. When the smoke and odour have completely disappeared, contact
your local distributor.
• Don't modify the adapter and the data cable.
Failure to do so may result in a short circuit or fire.
• Don't weld the battery without permission.
Such operation may damage the battery and result in leakage and explosion
of the battery.
• Avoid subjecting the battery to impacts (e.g., collisions, falls, etc.).
Such a condition may damage the battery casing or cause the battery to leak
or explode. leaking or exploding.
• Unplug the adapter from the wall outlet when charging. is not being
made.
The adapter may overheat if left connected to the power supply for a long
time. This may cause overheating, deformation, and fire.
2