Product Information; Concerns On Installation - Graco AFFIX I-SIZE R129 Owner's Manual

Always secure child in booster, even
on short trips, as this is when most
accidents occur.
DO NOT leave this booster, or other
items unbelted or unsecured in
your vehicle. Remove the booster
seat from the car if not regular used
and store in a dry, sun-protected
surrounding.
It's recommended not to use a
second-hand booster seat whose
history is not known. It may have
invisible structural damages or
defects due to incorrect usage/
storage.
DO NOT use any load bearing
contact points other than those
described in the instructions and
marked on the booster.
DO NOT install this booster under the
following conditions:
1. Vehicle seats facing sideways
or rearward with respect to the
vehicle's direction of travel.
2. Vehicle seats movable during
installation.
Consult the retailer for issues
concerning maintenance repair and
part replacement.
To avoid burns, never put hot liquids
in your booster's cupholders.
Product
Information
1. This is an i-Size booster seat
Enhanced Child Restraint System.
It is approved according to UN
Regulation No.129, for use primarily
in "i-Size seating positions" as
indicated by vehicle manufacturers
in the vehicle user's manual.
2. If in doubt, consult either the
Enhanced Child Restraint System
manufacturer or the retailer.
Product Booster seat
Materials
Plastics, Metal, Fabrics
Patent No.
Patents pending
Suitable for Child height 100cm-
150cm (Reference age
3.5-12 years).
Installation Forward facing (in
vehicle travel direction)
Booster Assembly
1 3
See images -
1
Squeeze the head support
adjustment lever first and then
slide in lower back support
under the fabric cover to
connect them together.
! CHECK to make sure two pieces
are securely snapped together
by pulling on them.
9
2
To attach the lower back support
to the base, hook the lower back
support over the seat bar hinge
on the base.
3
Rotate the lower back support
up while holding the booster
seat until it clicks into an upright
position.
Height Adjustment
– for Head Support
4
See image
4
Squeeze the head support
adjustment lever while pulling
up or down on the head support
until it snaps into one of the 10
positions.
Concerns on
Installation
5 8
See images -
Installation using
ISOFIX System
and 3-point belt
or using 3-point
belt only
9 23
See images -
9
Fit the ISOFIX guides with the
ISOFIX anchor points. The ISOFIX
guides can protect the surface of
the vehicle seat from being torn.
They can also guide the ISOFIX
connectors.
Press the ISOFIX adjusting
10
button to pull out the ISOFIX
connectors.
11 Rotate the ISOFIX connectors
180 degrees until they are
pointing in the direction of the
ISOFIX guides.
Line up the ISOFIX connectors
12
with the ISOFIX anchor points,
and then click both ISOFIX
connectors into the ISOFIX
anchor points.
! Make sure that both ISOFIX
connectors are securely attached
to their ISOFIX anchor points.
The colors of the indicators on
the both ISOFIX connectors
should be completely green.
! Check to make sure the booster
is securely installed by pulling on
the both ISOFIX connectors.
Press the ISOFIX adjustment
13
button to retract the seat back
to desired position.
To remove the booster:
14 Press the secondary lock button
first and then the button on
the ISOFIX connectors before
removing the booster from the
vehicle seat.
10