Kenwood KX-W1060 Instruction Manual page 11

How to record (deck B only)
M@ Ordinary recording
Since this unit is not designed for use with metal tapes, recording on metal tapes cannot be carried out.
1 Set up the cassette deck.
(D Insert a tape in deck B.
12
Deck B
e Check that the DUBBING switch is OFF.
@ Press the TAPE SELECTOR switch according to
the type of tape to be used.
aa NORMAL OLHIGH _/
Are SELECTOR Normal tape NORMAL
Il} Chrome tape+HIGH
@) Select the Dolby NR mode.
———rnencireey
Press to record with the DOLBY NR.
2 Select the source to be recorded.
Dolby noise reduction system
recording and playback.
Dolby B NR
The Dolby noise reduction system was developed to reduce the tape hiss noise generated during playback.
The optimum effect of the Dolby NR system is obtained when the same type NR system is used for both recording and playback. If a
different type NR system is used, playback is not performed correctly. Make sure that the same type noise reduction system is used for both
The most popular noise reduction system used in home audio components. Usually, Dolby NR system corresponds to B NR.
3 Set the recording level.
@ Play a music source.
(2) Enter the record-pause mode.
PAUSE REC PLAY
cme
(3) Adjust the recording level.
ws DEAK LEVEL METER see
J, CAINE OO 000 OOo Oonno
e10
@ Adjust so that segments around the 0 dB segment of the |
peak level meter light up at times.
) Stop playing the source.
Start recording.
@ Play the music source from the beginning.
@ Press the PAUSE key.
PAUSE
a,
Pe | Press once.
e@ Recording will start.
e The deck enters the stop mode automatically when the
tape has been recorded till the end.
Press the PAUSE key.
Press the PAUSE key again.
Press the STOP/EJECT key
then stop playing the music
source.
To pause recording
To resume recording
To stop recording
KX-W1060/KX-W594 (En) 11