In Case Of Difficulty - Kenwood KX-7050 Instruction Manual

In case of difficulty
What appears to be a malfunction may not always be serious. If your unit should not perform as expected, consult the table
below to see if the problem can be corrected before seeking help from your dealer or service representative.
Symptom
Sounds is not produced when the Play key
is pressed. :
Cause
The connection cords are connected im-
properly.
The head is dirty.
Tape is irregularly would and hard to take up.
A non-recorded tape is being played.
Remedy
Connect the cords properly referring to ''Sys-
tem connections'.
Clean the head referring to ''Cleaning the
head section''.
Replace the tape.
Play a recorded tape.
The deck does not work when an opera-
tion key is pressed.
The cassette holder is not closed completely.
The operation key was pressed immediate-
ly after closing the cassette holder.
The operation key was pressed within less than
4 seconds after the power was turned on.
Tape is not inserted.
Tape is irregularly wond and hard to take up.
Tape has been fully wound to reel.
Close the cassette holder completely.
Press the desired operation key in a few se-
conds after closing the cassette holder.
Press the desired operation key in more than
4 seconds after turning the power on.
insert a tape.
Replace the tape.
Change the tape transport direction or insert
the tape inversely.
DPSS malfunctions. The tape is not suitable for DPSS operation,
for example the spaces between tunes are
too short.
Read ''DPSS operation'.
CD PEAK SEARCH does not work.
The cassette holder does not open when
the OPEN/CLOSE key is pressed.
Sound is hoarse, or high frequencies are
not audible.
Sound is distorted.
Recording is not initiated when the REC
key is pressed.
24 KX-7050/KX-7050S (En)
A disc is not placed in the CD player.
The disc is dirty.
Place a disc in the CD player and press the
CD PEAK SEARCH key.
Clean the disc, place it in the CD player, and
press the [CD PEAK SEARCH J key.
The key is pressed during recording.
The head is dirty.
The tape is stretched or wrinkled.
The recording level was too high.
A tape recorded with distorted sound is be-
ing played.
Press in the Stop mode.
Clean the head referring to 'Cleaning the
head section''.
Replace the tape.
Adjust the recording level referring to 'How
to record"'.
Replace the tape.
The protection tab on the cassette has been
broken.
The cassette holder is not closed completely.
The recording level is set to the minimum po-
sition.
The TAPE A or B input selector is selected
on the amplifier.
Tape is wound to one side.
Use a cassette with unbroken tab. or close
the hole.
Close the cassette holder completely.
Adjust the recording level referring to ''How
to record''.
Press the input selector key of the source to
be recorded.
Insert the tape inversely.