Performance Memory - Yamaha Clavinova CVP-55 Owner's Manual

[Тт eee
To begin repeat playback first activate the A-B Repeat
mode by selecting phrase number "0" ("A-b" will appear on
the SONG NUMBER display), then start and stop playback
in the normal way.
SONG NUMBER
A-b
y A
O ©
* The specified A-B repeat points will be erased when a new
song number is selected.
Pause
Press the [Il PAUSE] button to temporarily stop DISK
ORCHESTRA playback. Press the [I] PAUSE] button
again to resume playback from the same point.
M PAUSE
* The [H PAUSE] button can not be used in the guide mode.
Rewind and fast Forward
During DISK ORCHESTRA operation the [44 REW]
and [>> FF] buttons function as follows:
e While playback is stopped or paused the [44 REW] and
[>> FF] buttons can be used to step backward or forward
through the song a measure at a time.
* The [44 REW] and [>> FF] buttons cannot be used in the
guide mode.
+ During playback the [>> FF] button causes fast playback
for as long as the button is held.
44 REW Вр ЕЕ
Pedal Pause/Next Phrase
If the left pedal is set for START/STOP operation using
the [LEFT PEDAL FUNCTION] button, it functions as a
pause/next phrase control during DISK ORCHESTRA play-
back: press once to pause, and again to continue from the
beginning of the next phrase. There may be a slight delay
after the pedal is pressed to "cue" to the beginning of the
next phrase.
* The pedal pause/next phrase function will not operate if the
guide, phrase repeat, or all songs repeat modes are active.
DISK ORCHESTRA COLLECTION
Disk Copy
The orchestra parts of songs from DISK ORCHESTRA
COLLECTION disks — the disk supplied with the CVP-55/
65 and others available from Yamaha — can be copied to
separate disks by following the "Disk Orchestra Collection
Song Copy" instructions given on page 31 of the "Disk
Control" section. Data copied in this way can be played
back and manipulated via the Performance Memory (page
28).
Performance Memory
The CVP-55 and CVP-65 feature a built-in "sequencer"
which can be used to independently record up to ten sepa-
rate parts of a single musical composition. The Performance
Memory has three RECORD and three PLAY BACK but-
tons, corresponding to track 1, track 2, and tracks 3 through
10. The music data that you record is stored on a 3.5" floppy
disk loaded into the Clavinova's disk drive unit. Before you
can record, however, you must "format" a new disk, as
described on page 30.
Recording
1. If you haven't already done so, make sure that a prop-
erly formatted disk is loaded into the Clavinova disk
drive (see page 30), and that the disk's write protect tab
is set to the "write" position (tab closed).
Write Protect tab Si m.
Write Protect OFF
2. Selecta SONG NUMBER between 1 and 60 for the
piece you are about to record (up to 60 different songs,
each with a different song number, can be recorded on a
single disk). Make sure the song number you select has
not already been used for a song previously recorded on
the disk you are using.
SONG NUMBER
I!
i
v A о ©
3. Only one track can be recorded at a time. If you press
[RECORD 1] you will record on track number 1. If you
press [RECORD 2] you will record on track number 2.
If you press [RECORD 3-10], you can choose to record
on track 3, 4, 5, 6, 7, 8, 9, or 10 by selecting the desired
track number using the [A] and [V] buttons below the
SONG NUMBER display while holding the [RECORD
3-10] button (the selected track number will appear on
the SONG NUMBER display). When a record track has
been selected the corresponding LED will light and the
metronome will sound at the currently selected tempo.
If you don't want to hear the metronome or rhythm
sound, turn the RHYTHM volume control all the way
down.
Озо
o: o?
< O O O
27