Voltage Conversion - Akai UC-K2 Service Manual

V. VOLTAGE CONVERSION
Models for Canada, USA, Australia, Japan and Europe
are not equipped with this facility.
This machine can be set to 11 OV, 120V, 220V or 240V
as required. Each machine is preset at the factory
according to destination. However, if voltage change is
necessary, this can be accomplished by a qualified
service personnel as follows:
1.
Disconnect power cord.
2. Loosen holding screws and remove upper cover.
3. With a flat bladed screwdriver rotate the selector,
located on the left hand side (Power Switch side),
until the arrow points to the desired voltage.
34
•
Fig. 4 Voltage Conversion