Advertisement
Control Panel Operation
Remote Control Operation
Notes:
• The heater should be powered on using the master switch before it can be
operated by remote control.
• The heater only starts working if the set temperature is higher than the room
temperature.
• The remote control requires 2x AAA size batteries (Not included).
• There might be a slight delay for the receiver to respond to the transmitter. Do
not press the buttons more than once within 2 seconds for the correct operation.
•
1.
Press the
effect ON/OFF.
2.
Press the 1000W button once for the low heat settings; press twice to switch off
the heat setting.
3.
The heating pilot light will appear green to indicate that the function is ON.
4.
Press the 2000W button once for the high heat settings; press twice to switch off
the heat setting.
5.
The heating pilot light will appear red to indicate that the function is ON.
6.
Press the DIMMER button to toggle between 5 different flame brightness levels.
18
1000W
2000W
button once on the remote control, this turns the heater and the flame
Turn heater off.
Turn heater to standby mode.
• Press to switch the flame effect on/off.
• Press and hold to toggle between 5 different
flame brightness levels.
Press to activate low level heating 1000W. The
heating pilot light will appear green to indicate
that the function is ON.
Press to activate high level heating 2000W. The
heating pilot light will appear red to indicate that
the function is ON.
Advertisement
