SubSurface Instruments LC-5000 Simple Operation Manual

GPS-equipped digital 4-point real-time leak noise correlator
Model: LC-5000 Simple Operation Manual <Basic Correlation Method>
(1) Attach the antenna or antenna base with cable +
antenna to the preamplifier, and turn on the
power of the main unit and the preamplifiers.
ON！
ON！
(2) Check the following on the main unit screen.
OK?
OK?
OK?
During daylight saving time, tap 'Equipment Settings'
from the menu and enable daylight saving time.
ON！
OK?
(3) Press the preamplifier switch to check and set the
preamplifier conditions.
Tap
Tap
Adjust time zone
before turning on DST.
The display changes to DST ON and
the clock advances by one hour. You
will not be able to change the time
zone at this stage.
Tap
Setting
2023.07.26 (E) ver.5.0
(4) If the antenna is attached directly to the
preamplifier, replace the antenna of the preamplifier
with the antenna base of the extension cable, and set
up the preamplifier and antenna.
OR
(5) Press the filter switch to set the filter items.
Tap
When the auto filter is executed, select the leak
position detection screen from the menu.
Tap
Close
1