Sony DVP-S330 Operating Instructions Manual page 11

If you have a digital component such as a
receiver (amplifier) with a digital connector, DAT
or MD
Connect the component via the DIGITAL OUT OPTICAL or
COAXIAL connector using an optical or coaxial digital
connecting cord (not supplied). |
When you play a DVD, set "DIGITAL OUT" in "AUDIO SETUP"
to "ON" and then set "DOLBY DIGITAL" to "D-PCM" and
"DTS" to "OFF" in the setup display. (page 47)
E When using an optical digital connecting cord
Optical digital connecting cord
(not supplied)
Take off the cap and plug in the optical digital connecting cord.
Receiver (Amplifier)
with a digital
connector, MD deck,
DAT deck, etc.
DIGITAL IN
CD/DVD player
W When using a coaxial digital connecting cord
Coaxial digital connecting cord
(not supplied)
CC | m |) =;
Receiver (Amplifier)
with a digital
connector, MD deck,
DAT deck, etc.
DIGITAL IN
COAXIAL
©)
CD/DVD player
OPTICAL
PCMIDTS!
DOLBY DIGITAL {AC-3)
Notes
* Refer to the instructions supplied with the component to be
connected.
¢ You cannot make digital audio recordings of discs recorded in
multi-channel surround format directly using an MD deck or
DAT deck.
When you make the connections above, do not set
"DOLBY DIGITAL" to "DOLBY DIGITAL" and "DTS" to
"ON." If you do, a loud noise will suddenly come out
from the speakers, affecting your ears or causing the
speakers to be damaged.
shy,
Cit you have a digital component with a built-in DTS or Dorby
Digital decoder
You can enjoy multi-channel surround sound by connecting the
component via the DIGITAL OUT OPTICAL or COAXIAL
connector using an optical or coaxial digital connecting cord (not
supplied). For details on hookups and settings, see page 12.
Setups for the player
Some setups are necessary for the player depending on
the components to be connected.
Use the setup display to change the various settings.
For details on using the setup display, see page 38.
To listen to the sound through speakers connected
to a receiver (amplifier) having a digital connector or
to output the sound to a digital component such as
a DAT or MD deck
When you play a DVD, set "DIGITAL OUT" in
"AUDIO SETUP" to "ON" and then set "DOLBY
DIGITAL" to "D-PCM" and "DTS" to "OFF" in the
setup display (page 47). These are the default settings.
11
papes Sunan |
eater