Table of Contents
Advertisement
The function has no effect on the
operation of the cooking zones.
STOP+GO
This function sets all cooking zones that operate
to the lowest heat setting.
The function does not stop the timer functions.
To activate the function: touch
comes on.
To deactivate the function: touch
previous heat setting comes on.
If you change the heat setting, the
function stops and the display
shows the new heat setting.
Lock
You can lock the sensors on the hob while
cooking zones operate.
Set the heat setting first.
To activate the function: touch
comes on for 4 seconds. The Timer stays on.
To deactivate the function: touch
previous heat setting comes on.
When you deactivate the hob, you
also deactivate this function.
The Child Safety Device
This function prevents an accidental operation
of the hob.
To activate the function: the hob must be
deactivated. Touch
.
comes on for 4 seconds.
To deactivate the function: the hob must be
deactivated. Touch
.
comes on for 4 seconds.
To override the function for only one
cooking time: activate the cooking zone.
comes on. Touch
the heat setting in 4 seconds. You can
operate the hob. When you deactivate the
appliance the function operates again.
www.zanussi.com
.
. The
.
. The
until
flashes. Touch
until
flashes. Touch
until
comes on. Set
OffSound Control (Deactivation and
activation of the sounds)
Deactivate the hob. Touch
Touch
for 3 seconds.
Touch
of the timer to choose one of the
following:
•
- the sounds are off
•
- the sounds are on.
To confirm your selection wait until the hob
deactivates automatically.
When the function is set to
sounds only when:
• Minute Minder comes down
• Count Down Timer comes down
• you put something on the control panel.
Power management function
• Cooking zones are grouped according to the
location and number of the phases in the
hob. See the illustration.
• The right cooking zones and the top oven
are connected to the same phase.
• Each phase has a maximum electricity load.
The oven is more important than the hob.
• The function divides the power between
cooking zones and the oven connected to
the same phase.
• The function activates when the total
electricity load is exceeded.
• The function decreases the power on the
cooking zones to prevent a circuit overload.
• The heat setting display of the reduced
zones changes between two levels.
for 3 seconds.
or
comes on.
you can hear the
11
Advertisement
Table of Contents
