Accessory Information - Panasonic SC-BT100 Operating Instructions Manual

RQT9129
Operations in these instructions are described mainly with the
remote control, but you can perform the operations on the main
unit if the controls are the same.
Accessory information
System ' SC-BT100
Main unit SA-BT100
Front speakers SB-HF100
Center speaker SB-HC100
Surround speakers SB-HS100
Subwoofer SB-HW560
Digital transmitter SH-FX67T
Wireless system SE-FX67
Please check and identify the supplied accessories. Use numbers indicated in parentheses when asking for replacement parts.
(Product numbers correct as of February 2008. These may be subject to change.)
Only for U.S.A.: To order accessories, refer to "Accessory Purchases" on page 46.
Only for Canada: To order accessories, call the dealer from whom you have made your purchase.
J
Remote control
(N2QAKB000061)
1 2 Remote control batteries 1 AM loop antenna 1
(N1 DAAAA00002)
1 Video cable 1 Sheet of speaker 5 Speaker cables
(K2KA2BA00001) cable stickers [REE×0859-L (White)]
[REEX0867A-L (Red)]
[REEX0858-L (Green)]
[REEX0860A-L (Blue)]
[REEX0868A-L (Gray)]
FM indoor antenna
(RSA0007-M)
Jj
2 AC power supply cords
(K2CB2CB00021)
oFor use with this unit only. Do not use
them with other equipment. Also, do not
use cords for other equipment with this
unit or wireless system.
The enclosed Canadian French label sheet corresponds to the English display on the front and back side of the unit.
WARNING:
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK OR
PRODUCT DAMAGE,
aDO NOT EXPOSE THIS APPARATUS TO RAIN, MOISTURE,
DRIPPING OR SPLASHING AND THAT NO OBJECTS FILLED
WITH LIQUIDS, SUCH AS VASES, SHALL BE PLACED ON THE
APPARATUS.
eUSE ONLY THE RECOMMENDED ACCESSORIES.
aDO NOT REMOVE THE COVER (OR BACK); THERE ARE NO
USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO
QUALIFIED SERVICE PERSONNEL.
CAUTION!
THIS PRODUCT UTILIZES A LASER.
USE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE
OF PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN
MAY RESULT IN HAZARDOUS RADIATION EXPOSURE.
DO NOT OPEN COVERS AND DO NOT REPAIR YOURSELF.
REFER SERVICING TO QUALIFIED PERSONNEL.
(For wireless system)
The following mark and symbols are located on bottom of the unit.
CAUTION *
CAUTION: TO REDUCE THE RISK OF ELECTRIC
SHOCK, DO NOT REMOVE SCREWS.
NO USER-SERVICEABLE PARTS
INSIDE.
REFER SERVICING TO QUALIFIED
SERVICE PERSONNEL.
The lightning flash with arrowhead symbol, within
an equilateral triangle, is intended to alert the user
to the presence of uninsulated "dangerous
voltage" within the product's enclosure that may be
of sufficient magnitude to constitute a risk of
electric shock to persons.
_The point an equilateral triangle
exclamation within
is intended to alert the user to the presence of
important operating and maintenance (servicing)
instructions in the literature accompanying the
appliance.
THE FOLLOWING APPLIES ONLY IN THE U.S.A.
FCC Note:
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
._an radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
an, the user is encouraged to try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC caution; To maintain compliance with FCC regulations, shielded interface
._ables must be used with this equipment. Operation with non-approved
equipment or unshielded cables may result in interference to radio and TV
reception. Any changes or modifications not approved by the party responsible
lor compliance could void the user's authority to operate this equipment.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received including interference
that may cause undesired operation.
Responsible Party:
Panasonic Corporation of North America
One Panasonic Way
Secaucus, NJ 07094
Support Contact:
Panasonic Consumer Electronics Company
Telephone No.: 1-800-211-PANA (7262)
WARNING:
antenna used for this transmitter must not be co-located in con unction with an
ather antenna or transmitter.
THE FOLLOWING APPLIES ONLY IN CANADA.
(For wireless system)
I
Th s C ass B d g ta apparatus comp es with Canadian ICES-003. I
This device complies with RSS-210 of the IC Rules. I
Operation is subject to the following two conditions:
I
(1) This device may not cause harmful interference,
(2) This device must accept any interference received including interference
that may cause undesired operation of the device.