Table of Contents
Advertisement
Changing Speeds
To reduce risk of shock or
accidental startup, always
disconnect machine from
power before adjustments,
maintenance, or service.
Variable-Feed Speeds ...................... 7–86 FPM
Users can change the feed rate by adjusting the
variable-speed adjustment dial on the control
panel.
To change speed:
1.
Press SET button on control panel, as shown
in Figure 23.
Note: Current feed rate will flash for up to
10 seconds, after which SET button must be
pressed again to adjust feed rate.
Variable-Speed
Adjustment Dial
Figure 23. Location of SET button and variable-
speed adjustment dial on control panel.
2.
Rotate variable-speed adjustment dial to
desired feed rate.
Model T33295 (Mfd. Since 03/23)
Adjusting Roller
The Model T33295 can be positioned to feed
workpieces so the rollers are angled relative to
the machine fence from 45°–90°. For example, it
can be positioned at 90° to feed stock against a
fence, or positioned at 45° for making bevel cuts
on a jointer.
Use the controls shown in Figure 24 to position
the power feeder for incline feeding.
Upper Elbow-
Joint Lock
Lower Elbow-
Joint Lock
Figure 24. Location of controls for re-positioning
Tools Needed
SET
Open-End Wrench or Socket 14mm ................. 1
Button
To position power feeder for vertical/incline
feeding:
1.
DISCONNECT MACHINE FROM POWER!
2.
Loosen rotation lock and swing power feeder
off of machine table (see Figure 24).
3.
Loosen (2) hex bolts on upper elbow-joint,
rotate upper elbow to desired angle, then
tighten hex bolts (see Figure 24) to secure
setting.
4.
Loosen upper elbow-joint lock and lower
elbow-joint lock (see Figure 24).
Angle
x 2
Rotation Knob
power feeder for incline feeding.
Qty
-23-
Advertisement
Table of Contents
