Converting Voltage To 240V - Grizzly G0964 Owner's Manual

Converting Voltage
to 240V
The voltage conversion MUST be performed by
an electrician or qualified personnel.
To perform the voltage conversion, rewire the
motor, replace the magnetic switch, and install the
correct plug.
IMPORTANT: If the diagram included on the
motor conflicts with the one in this manual, the
motor may have changed since the manual was
printed. Use the diagram provided on the motor.
Items Needed
Wire Cutters/Strippers ....................................... 1
Wrench or Socket 12mm ................................... 1
Open-End Wrenches 24mm .............................. 2
Phillips Head Screwdriver #2 ............................ 1
Wire Nut (14#AWG) ........................................... 1
Electrical Tape ................................... As Needed
Magnetic Switch 240V (#P0964016X) ............... 1
NEMA Plug 6-15 ................................................ 1
To convert machine to 240V operation:
1.
DISCONNECT MACHINE FROM POWER!
2.
Cut off included 5-20 plug.
3.
Remove (14) hex bolts and flat washers
shown in Figure 6 to remove motor access
cover.
Figure 6. Motor access cover and fasteners.
Model G0964 (Mfd. Since 04/23)
4. Remove screw shown in Figure 7 to remove
motor junction box cover.
Motor Junction Box Cover
Figure 7. Motor junction box cover and screw.
Qty
5. Remove (2) wire nuts indicated in Figure 8.
Motor
Access
Cover
x 14
Wire Nuts to
Remove
1
3
4
2
1
3
Start
Capacitor
400MFD
125VAC
Prewired 120V
Figure 8. Motor prewired for 120V.
MOTOR 120V/240V
Ground
Run
Capacitor
50uF
250VAC
-13-