OPERATION REQUIREMENTS
LOCATION OF YOUR WASHER
1.
℃
2. In an area where it will come in contact with curtains or drapes.
3. On carpet. The floor MUST be a hard surface with a maximum slope
of 1/2
NOTE: If floor is in poor condition, use
3/4
IMPORTANT: MINIMUM INSTALLATION CLEARANCES
Back = 3" (7.6 cm)
ELECTRICAL REQUIREMENTS
WARNING
•
DO NOT USE AN EXTENSION CORD OR AN ADAPTER PLUG
accordance with local codes and ordinances.
CIRCUIT - Individual, properly polarized and grounded 16-amp branch
circuit fused with 16-amp time -delay fuse or circuit breaker.
POWER SUPPLY - 2-wire with ground, 120V~, single-phase, 60Hz,
power supply cord is accessible when the washer is in an installed
position.
6