Minimum Mounting Height; Avoidance Of Back Flow; Safety Of Children; Replacement Of Supply Cord - Schweigen BR550 Installation Manual

Table of Contents

Advertisement

2. Your Safety

Minimum Mounting Height

This fan unit is intended for mounting at a minimum height of 2.1 metres (measured to the lower part of the
fan impeller) above floor/ground level.

Avoidance of Back Flow

Care should be taken to avoid the back flow of gases into the room.

Safety of Children

This fan is not intended for use by young children or infirm persons without supervision.

Replacement of supply cord

If the supply cord is damaged, it must be replaced by a service agent or suitably qualified person in order
to avoid a hazard.

Why Flexi-duct

Some internet sites strongly recommend the use of rigid ducting over fully flexible ducting.
The use of a complete rigid or semi-rigid ducting system will cause an organ piping effect to occur; like a
didgeridoo, where a noise is produced at one end of a hollow rigid pipe and the noise is amplified out the other.
The motor system puts the noise outside the house.
Warning: Installation without the use of at least the minimum recommended length of acoustically matched
flexi-ducting will void performance expectations. Any installation problems must be reported to Schweigen.
Call outs relating to incorrect installation will result in a service fee direct to the customer. Schweigen takes no
responsibility for problems caused by faulty installation. Faulty installation may void warranty. An experienced
installer list can be obtained from the Schweigen website www.schweigen.com.au or call 1300 881 693.
Page 6

Advertisement

Table of Contents
loading

This manual is also suitable for:

Br552Brw650Brw652Brb750Brb752

Table of Contents