Working Instructions - Fein VersaMAG VISE Series Instruction Manual

Working instructions.

For switching the magnet ON
(figure 2).
Before carrying out any work with the prod-
uct, check that the clamping screws are tight.
Keep bystanders away while using the prod-
uct.
Clamp and machine workpieces only when
the lever position is set to ON.
Pay attention that the set-up surface for
the magnetic foot is flat, clean, rust-free
and ice-free. Remove varnish, putty/filler
layers and other materials. Prevent an air gap
between the magnetic foot and the set-up
surface. The air gap reduces the magnetic
holding power.
Do not use this product on hot surfaces
> 80 °C, as this will result in a permanent
reduction of the magnet holding power.
Use the magnet only on magnetic surfaces
with a wall thickness of at least 4 mm.
The magnetic holding power can be
switched step by step with the hand lever.
For positioning, set the hand lever to 30%;
to switch the magnet on, set the hand lever
to ON.
Use personal protective equipment accord-
ing to the application.
Fig. 2
30%
2.
3.
ON
2.
3.
en
1.
Hand lever, magnet
1.
7