Table of Contents
Advertisement
Additional Functions
Passcode Creation
•
You can add a passcode (PIN) to the Wireless Valve Output Module to
prevent unauthorized access by other Bluetooth smartphone users.
•
It's important to remember your passcode or store it in a safe place. If
you forget or lose the passcode, other users may no longer be able to
access the Wireless Valve Output Module and all the Wireless Valve Link
information until it's bypassed. Do not use a PIN that you use for other
apps and functions.
Database Recovery
•
The recovery feature is used when a Wireless Valve Output Module must
be replaced for service reasons or is exchanged with another device.
•
The new Wireless Valve Output Module must be relinked to all the
Wireless Valve Linksin the field to operate.
•
Install the new Wireless Valve Output Module, connect it with the app,
and choose the Recover Database feature.
•
The app will prompt you to enter the serial number of a known device
(either a Wireless Valve Link or a Repeater) within the system.
•
The Wireless Valve Output Module will use this valid serial number to
search for the new device. The Wireless Valve Output Module will then
attempt to reach all operational Wireless Valve Links or Repeaters within
range. This can take up to 30 minutes.
•
When the process is complete, a notification will appear. If all Wireless
Valve Links were found, the Wireless Valve Output Module will be ready
to irrigate again without further field addressing.
Factory Reset
•
The factory reset option will completely erase all Wireless Valve Output
Module information, including the Wireless Valve Link database, Channel
and Site ID assignments, and Repeater configuration. The whole system
will need to be set up again to restore operations.
•
From the WVOM Settings menu, select Factory Reset to revert the
system to default settings.
6
Firmware Updates
•
Both the Wireless Valve Output Module and the Wireless Valve Links
can be updated in the field over the air (OTA), if new firmware becomes
available.
•
When the process is complete, a notification will appear. If all Wireless
Valve Links were found, the Wireless Valve Output Module will be ready
to irrigate again without further field addressing.
Note
Firmware updates are large downloads and can take up to 2 hours.
Do not start an update if you need to irrigate or perform other
diagnostic functions within this time.
Advertisement
Table of Contents
