Timer Recording (Main Operation, Cancel-Ctear Or Replace, Program Contents) - Panasonic Omnivision VCRplus+ PV-4611 Operating Instructions Manual

Timer Recording
Your VCR can be set up to do a recording
while you are away or otherwise occupied.
Up to 8 programs can be placed in
memory. You can choose to record one
time, daily, or weekly.
Se list before you begin.
O All connections are made.
(See pages 6-9.)
[C] TV and VCR are plugged in and turned on.
C] VCR/TV selector is set to "VCR."
C] Clock is set to correct time.
L] Record tab in place.(See page 5.)
Multi Function STOP/EJECT
Display
Important notes when using a
DSS receiver
* When recordin
DSS receiver, the DSS receiver
must be left on.
programs via a
* When recording programs via an
antenna or cable, the DSS receiver
must be turned off.
*
(E
=
tr]
UN
16
Push PROG to display
the program screen.
PROG * lf a program is already in
memory, use the Wheel to
select an unused program
number.
Rotate and push the
WHEEL to select and
set the DATE.
Daily and Weekly Timer Recording
If you want the program to be recorded daily
(Mon thru Fri) , enter DAILY in place of the
DATE in step 2. If you want the recording to
be on a weekly basis, enter WEEKLY MON,
TUE, etc..
Rotate and push the
WHEEL to select and
set remaining items at
right.
To Make Corrections
START STOP
ELECT START DATE
BY ROTATING WHEEL
PUSH WHEEL»
TO END PUSH PROG KEY
Todays Date
E RR 78-91" 31
: xample 1
MN Whee! Selection Order |
WEEKLY SUN DAILY — g"
START STOP
TO EN
BY ROTATING WHEEL
: PUSH WHI
TO END PUSH PROG KEY
Remaining Items
to be set:
* START time
* STOP time
* CH(annel) number,
or LINE for outside
source recording.
* Speed (SP, LP, SLP).
Repeatedly push the Wheel to move forward, or the CLEAR button to
move back to the desired item. Then, select and set continue with step 3.
Push PROG to end
the program.
* |f you want to enter more
programs, select a blank
program number with Wheel
and repeat steps 2 and 3.
PROG
Push PROG to exit
this mode.
PROG
VCR
Push VCR POWER
off to set the timer.
* When recording programs via
a cable box, make sure the
cable box is left ON and tuned
to the desired channel.
P DT STRAT STOP CH SPD
1DAY 9: -00A 12 :00A = SP
2 :
-B:ROTATE
Multi Function Display
If the cassette record tab is missing at the time the VCR power is turned OFF, the tape ejects and i
the TIMER indicator flashes.
If the start times of two programs overlap, the lower numbered program will have priority.
If the start time for a timer recording comes up during a normal recording or One Touch Recording (page 15),
the timer recording will not be performed.
If there is a power interruption of more than one minute, the recording not be performed or continue.
* I "PROGRAM IS INCOMPLETE" appears on-screen in step 4, check all entries and make necessary corrections .