Table of Contents
Advertisement
Bracket Replacement Instructions
The BF1600 Controller Card and auxiliary connection card are shipped with assembled high-profile brackets. If this form factor is suitable for your
requirements, you can skip the remainder of this section and move to
the short bracket that is included in the shipping box, please follow the instructions in this section.
Due to risk of damaging the EMI gasket, it is not recommended to replace the bracket more than three times.
To replace the brackets you will need the following parts:
•
The new bracket of the proper height
•
The 2 screws saved from the removal of the brackets
Removing the Existing Bracket
1.
Using a torque driver, remove the two screws holding the bracket in place.
2.
Separate the bracket from the Auxiliary Connection card.
3.
Save the two screws.
Installing the New Bracket
1.
Place the bracket onto the card until the screw holes line up.
2.
Screw on the bracket using the screws saved from the bracket removal procedure above.
Use a torque driver to apply up to 4.4 lbs-in torque on the screws.
Installation Instructions
This section provides detailed instructions on how to install your BlueField 1600 Controller Card in a JBOF system.
Installation
Instructions. If you need to replace the Auxiliary Connection Card with
76
Advertisement
Table of Contents
