GE GNSV70FBL Owner's Manual And Installation Instructions page 13

Installation Instructions.
BatteryInstallation
I. Use a small flat blade screwdriver or coin to remove the battery tray (A) at the side of the fimcet base.
2. Install one CR2032, 3 volt batte_ y (g) + side down into the batte_' tray (A) (Fig. 12).
3. Slide tray into fimcet base ((:) until the battery tray (A) edge is flush with the side otthe base.
4. The blue light (D) will flash 5 times, indicating a proper installation and system reset.
5. Nommllv the light is ofl_ _Mter 6 months of use, the light will flash again eve_y 30 seconds, indicating the proper time to _eplace the
filter canister:
NOTE."Theblue hght may stop blinklbg if it # allowed to blink for an extendedperiod of time. Toemure proper operation, the battery should be replacedwith
every filter change.
{D) Bkle light _ _ _ (B) Battery
(C) Faucet base _ _ + (_ (A) Battery tray
Fig. 12
13