Download Print this page

Viking E-30 Technical Practice page 3

Handsfree speaker phone with dialer
Hide thumbs Also See for E-30:

Advertisement

F
e
a
t
u
r
e
s
O
F
e
a
t
u
r
e
s
O
Mounting Screws:
6-32 x 0.75" long
flathead with 5/64" hexdrive, 18-8 stainless
steel to prevent corrosion.
Faceplate: 14 guage 304 stainless steel.
Condensation Drain Hole
DIP Switches (see page 7):
1: Normal Audio Detection
2: Increased Audio Detection
Speaker Volume
Microphone Volume
DIP Switches (see page 7):
1: Push Button Feature (connect / disconnect)
2: Auto Answer Feature (on/off)
3: Programming Switch (normal/programming)
I
n
s
t
a
l
l
a
t
i
o
I
n
s
t
a
l
l
a
t
i
o
A. Mounting
IMPORTANT: Electronic devices are susceptible to lightning and power station electrical surges from both the AC outlet and the
!
telephone line. It is recommended that a surge protector be installed to protect against such surges. Contact Panamax at (800)
472-5555 or Electronic Specialists Inc. at (800) 225-4876.
Caution: When warm air comes in contact with cold surfaces, such as outside walls and conduits, it causes condensation. To prevent
condensation from accumulating inside the E-30 always bring conduit into the bottom of the unit. If this is not possible, drill a 1/4" diam-
eter hole in the bottom of the gray plastic box.
*Note: Peel off paper liner and adhere gasket to the back of the faceplate, centering it over the four corner mounting holes. Be careful
to position the modular jack inside the chassis as not to damage the components on the circuit board.
4.0"
Front View of
Plastic Rough-In
Box (included)
Wire knock out
(2) Standard flat head dry wall
(sheet rock) screws (not included)
Important: The E-30 will NOT mount
to a standard double gang box.
Note: The plastic rough-in box (part # 259576) may be purchased separately
in advance. Go to www.vikingelectronics.com and click on "Spare Parts".
v
e
r
v
i
e
w
v
e
r
v
i
e
w
VIKING
©
ON
1
n
n
2.1"
*
Adhere gasket to front panel,
centering over mounting holes
5.0"
Push to Call Button
Red Off-Hook LED Indicator
Condensation Drain Hole
(4) 6-32 X 3/4" stainless steel, flat
head, hexdrive, screws (included)
Call
2
3.25"
5.22"
5.14"
Condensation
Drain Hole
Front View of Optional
2.25"
VE-5x5 (not included)
The optional VE-5x5 Surface Mount Box is designed
to be surface mounted to a single gang box, double
gang box or VE-GNP gooseneck pedestal (right).
Need More Information on VE-5x5 or VE-GNP?
?
Call (715) 386-4345 and select 424.
Microphone:
Omni-directional microphone
with protective water-resistant cloth.
Speaker: Mylar speaker with rubber gasket to
maintain water-tight seal and eliminate water
deterioration.
Speaker Screen:
Stainless steel speaker
screen with 0.018" diameter holes to prevent
punctures from paperclips, etc.
Push Button Switch:
Push to initiate call,
push again to disconnect. Solid 304 stainless
steel internally sealed per IP67.
LED: Lights red for "In-Use" indication.
Faceplate Gasket: 1/8" thick closed cell PVC
to provide a water-tight seal.
Earth Ground: To increase surge protection,
loosen the screw labeled
(as shown) and
fasten a wire with spade terminal (included)
from the mounting screw to Earth Ground
(grounding rod, water pipe, etc.)
(4) 0.38" diameter
(for gooseneck mounting)
(4) 0.2 x 0.43 slots
for double gang box
(2) 0.2 x 0.43 slots
for single gang box
(1) .74" dia
3.0" 3.3"
3.0"
Rear View of VE-5x5
(not included)
E-30-EWP shown
with Viking Model
VE-GNP
Gooseneck
Pedestal
3

Hide quick links:

Advertisement

loading

This manual is also suitable for:

E-30-ptTbb-1E-30-ewp