Table of Contents
Advertisement
5.1.1 Top cover removal
of the set.
Also be sure that the battery is removed.
Refer to Fig. 5-1
Remove the two screws in the bottom of the set.
Fig. 5.1
5-1
For the next part refer to Fig. 5-2
Open up the screen by using the latches on tly sides of
the set.
Remove the coverplate which covers two scr'¥s which
hold the RAM-expansion slots.
Unlock screws (A) and remove the coverplate.
The keyboard can now be slided in the direct? of arrow B
for about 1 - 2 cm. Be carefull not to damagelhe key-
board connection wire D.
Remove screw C which hold the uppercase.
Remove the flat-cable to the LCD-display by liting the con-
nector and sliding the cable out, see Fig. 5-3.
Lift the topcover for about 3 cm and disconnect two connec-
tors from the LCD-backlight and the battery, s°@ Fig. 5-4.
Remove the uppercover from the set and youCan access
the motherboard and the power board.
MDA.03023
728/124
Fig. 5.2
MDA.03024
T28/124
CS 55 807
Advertisement
Table of Contents
