Panasonic PT-L701 XU Operating Instructions Manual page 41

LAMP indicator
Indicator
display
Illuminated (red)
Flashing (red)
Problem
It is nearly time to
replace the lamp
unit.
An abnormality has been detected in the lamp
circuit.
Possible
cause
• Does "REPLACE
LAMP" appear on
the screen after
the projector is
turned on?
• The power may
have been turned
on immediately
after it was turned
off.
• There may be an
abnormality in the
lamp circuit.
Remedy
• This occurs when
the operation time
for the lamp unit is
nearing 1800
hours, (when
LAMP POWER
has been set to
"STD") Ask your
dealer or an
Authorised
Service Center to
replace the lamp
unit.
• Wait for a while
until the lamp unit
cools down before
turning the power
back on again.
• Turn off the MAIN
POWER switch by
following the
procedure given
on page 23, and
then contact an
Authorised
Service Center.
NOTE:
• Be sure to turn off the MAIN POWER switch by following the procedure
given in "Turning off the power" on page 23 before carrying out any of the
procedures in the "Remedy" column.
• If the main power turns off after the TEMP indicator starts flashing, it
means that an abnormality has occurred. Please contact an Authorised
Service Center so that the necessary repairs can be made.