osann Flux Isofi x Manual page 24

EN
2) Size class 100–150 cm, forward-facing
1 . The 5-point harness of the child car seat and the top-tether strap must be stowed as previ-
ously described. These are not needed for children of this height.
2 . Press the two side Isofi x connector buttons to extend the length of the Isofi x connectors.
3 . Guide the Isofi x connectors to the Isofi x anchor points on the car seat and snap them into
place.
4 . Push the child car seat in until it rests securely against the backrest of the vehicle seat. Ensure
that both Isofi x indicators have turned green.
5 . Thread the diagonal belt of the 3-point seat belt in the car through the diagonal belt guide on
the headrest of the child car seat.
6 . Put your child in the child car seat.
7 . Adjust the height of the headrest so that the child's head is fully in the headrest and the diag-
onal belt comes out through the belt guide at the level of the child's shoulders.
8 . Fasten the belt buckle of the 3-point seat belt until you hear a click.
9 . Make sure that both the diagonal belt and the lap belt run along the second lap belt guide
(below the armrest) on the child car seat, which faces the car's seat belt buckle.
10 . Pull on the diagonal strap to tighten it. Make sure that the straps are not twisted.
11 . Install the side impact protector as previously described.
Installation without Isofi x:
Alternatively, the child car seat can also be fi tted with the 3-point car seat belt only for children
100–150 cm in height. Attaching the seat with the Isofi x connectors is not absolutely essential
but is recommended.
- 24 -