Philips 6002 Series Service Manual page 11

3.2.5 Disassemble wire
Unplug 2pin power cord from the connector of motherboard and put them at appointed position.
1.
2. Exert appropriate force to unplug backlight wire from the backlight connector of power board.
3. Unplug screen-wire from the socket of driver board,unfasten the buckle of M/B,and unplug screen-wire and put it at appointed
position.
Exert appropriate force to unplug WIFI connecting wire vertically from B/M and WIFI board's connector,put it at appointed
4.
position.
5. Exert appropriate force to unplug three-terminal wire from power board and motherboard's socket,and put them at appointed
position.
6. After self-check OK,flow it into next station by foot switch
3.2.6 Disassemble IO baffle, mainboard,power board
1. Use electric screwdriver to disassemble 4pcs Ф3×3mm screws, and put them at appointed position.
2. Take down mainboard side baffle,lower baffle from back plate.
Use electric screwdriver to disassemble 7pcs M3×7mm screws，and put it at appointed position.
3.
4. Use electric screwdriver to dismantle 1pcs Ф3×8mm screw and put them at appointed position
5. Take down mainboard module and put it at appointed position
4.
Take down power board form back panel,and put it at appointed position
5.
After self-check OK,flow it into next station by foot switch.
11