Table of Contents
Advertisement
8. AMP TEST MODE
• This mode is used to measurement and test of the AMP con-
nection.
Procedure:
?/1
1. Press the [
] button to turn the power on.
x
N
2. Press three buttons [
], [
the this mode, blink to segments ("SA-CD" and "CAT") on FL
display.
3. Press [DISPLAY] button of the remote commander. When the
this mode is displayed as "MEASURE" on FL display.
Whenever the [DISPLAY] button is pressed, the AMP test
mode changes in the following order.
MEASURE 7SAFETY
MEASURE: AMP measurement mode
SAFETY:
AMP regulations, temperature, character mode
4. Press [MUTING] button on the remote commander. When the
this mode is displayed as "VOL N" on FL display.
Whenever the [MUTING] button is pressed, the VOL test
mode changes in the following order.
VOL N 7VOL M/M
VOL N:
Turn the [VOLUME] control, the display is
change in succession (MIN y MAX)
VOL M/M: Turn the [VOLUME] control in the direction of
(+) is change to "MIN", turn the direction of (–)
is change to "MAX".
5. To exit from this mode, press the [
RESET" and turn the power off.
HCD-DZ285K/DZ290M/DZ585K/DZ590M/DZ685K/DZ690M
Z
] and [
] simultaneously. When
?/1
] button to "COLD
9. DEMO PLAY MODE OUT
It is a mode to release the demonstration reproduct by the dedicated
demonstration disc.
1. During playback the DEMO Disc, press the [
buttons for fi ve seconds simultaneously.
2. The message "DEMO OFF" is displayed, a mode to reproduct
the demonstration is released.
10. DMPORT (DIGITAL MEDIA PORT) TEST
1. Connect the DMPORT CHECK JIG (P/N: J-2501-309-A) with
the terminal DMPORT.
?/1
2. Press the [
] button to turn the power on.
3. Confi rm that both LEDs of the DMPORT confi rmation JIG
lights. (Confi rmation the power supply line.)
4. Set the [FUNCTION] button with "DMPORT" on this model.
x
5. Press three buttons [
], [
ously, the DMPORT test mode is activated.
6. It is confi rmed that "DMPORT OK" is displayed on this set
display. (Confi rmation of communication line)
7. To a pin jack of the DMPORT confi rmation JIG input informa-
tion relevant to audio signal (sine-wave 1.0Vrms) and compos-
ite video signal (white 100% 1.0Vp-p, color bar, etc.)
8. Confi rm the output of speakers and monitor TV. (Confi rmation
of analog signal)
9. To exit from this mode, press three buttons [
[FUNCTION] simultaneously.
DMPORT
CHECK JIG
color pattern
(P/N: J-2501-309-A)
generator
VIDEO
J001 %
AF oscillator
AUDIO
x
] and [
N
] and [FUNCTION] simultane-
x
N
], [
J4001
SET
MAIN
board
TV
IO-COMPONENT
board
CN451
FL speaker,
FR speaker
SPEAKER
TB5301
board
N
]
] and
19
Advertisement
Table of Contents
