Advertisement
2. Select the EFFECTS LOOPS and CONTROL FUNCTIONS you want to turn on with that preset.
3. Repeat for the other presets you wish to programme. There is no store button, G3 remembers every time
you press a button and automatically saves after each step.
STOMPBOX MODE
This enables you to add any loop or combination of loops and CONTROL FUNCTIONS on top of any standard
PRESET. This enables you to build sounds on the fly giving you the ultimate flexibility.
1. Choose the PRESET you want to turn into a STOMPBOX mode preset, E.g. using PRESET 10.
2. Select the LOOP(s) you want to turn on. In this example, I want to add a delay that is in LOOP
9
3. Now make sure everything else is turned off including OUTPUTS and PHASE OUT 2.
4. Now press the STOMPBOX MODE button. A little yellow light will turn on next to the main preset light.
This means this preset is now set up in STOMPBOX mode.
Preset 10 is now in STOMPBOX and is used to add the delay in LOOP 9, ON TOP of any other preset.
You can have as many STOMPBOX MODE presets as you like. In the STANDARD
setting, all stompbox mode presets will clear when you press any normal preset,
but you can set this to stay on in the DEEP EDIT MENU, where you can also set
your STOMPBOX preset up in momentary.
NAVIGATING THE DEEP EDIT MENU
Editing the menu options in G3 has been designed to be as intuitive as possible, but for additional guidance
please refer to the full manual.
Press the
button on the left-hand side of the LCD screen to
access the DEEP EDIT MENU.
Use footswitches 1,2,3 & 4 (labelled with
navigate through the menu to edit;
MIDI, PARALLEL & WET/DRY SIGNAL PATHS, DELAY/REVERB TRAILS,
PRESET NAMES, BLUETOOTH SOFTWARE UPDATES, STOMPBOX
MODES, PRESET BANK COPY & PASTE, SCREEN BRIGHTNESS, etc.
G3S Quickstart Guide V.1 / ©The GigRig Ltd 2023
) to
Advertisement
