Viking ACA-1A Software Manual

Important: Certain programming features may change and will be listed on this
document, but this document must be used in conjunction with the ACA-1A Technical
Practice (Fax Back Document 007).
Important: The microprocessor and ACA-1A are sensitive to static electricity.
Personnel and work area should be grounded before handling.
1. Disconnect the AC power to the unit.
2. Remove the two phillips screws on the bottom of the unit.
3. Remove the top half of the plastic cover.
4. Remove the existing microprocessor Z5 from the socket by prying it our with a
small screwdriver (see the diagram to the right).
5. Install the new microprocessor into the socket, with the indent in the
microprocessor as shown. Important: Be sure all pins are in the sockets before
pressing into place.
6. Replace the plastic cover.
7. Reconnect the AC power.
A. Speed dial numbers
Up to 10 speed dial memory locations can be programmed ((9) 16 digit, (1) 32 digit).
Note: Special characters such as Q's, #'s and pauses require 1 digit.
Actual Number
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ #01 _____________
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ #02 _____________
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ #03 _____________
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ #04 _____________
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ #05 _____________
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ #06 _____________
Telecommunication Peripheral Products
Application Note
Installing Optional Software
http://www.VikingElectronics.com
E-mail...Sales@VikingElectronics.com
Installation
Programming
Access Department/
Code Location
in the ACA-1A
Using optional software, the ACA-1A can
be programmed to provide many
additional features and be compatible with
many different systems. Contact Viking
Product Support for information on special
software modules available.
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ #08* ____________
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ #09* ____________
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ #00* ____________
Software Installation
and Programming
September 15, 1998
Z5
Access
Actual Number
Code
#07*
#07* ____________
Department/
Location