Assembly - Sears PRO-FORM CrossTrainer 56 User Manual

ASSEMBLY
Assembly requires two persons. Place all parts of the crosstrainerin a cleared area and remove the packing
materials. Do not dispose of the packing materials until assembly is completed. In addition to the included
allen wrenches, assembly requires a phillips screwdriver
C----_ • _ , an adjustable wrench _
and
a
rubber mallet
As you assemble the crosstrainer, use the drawingsbelow to identifythe small parts used in assembly.The
number in parenthesis below each drawing refers to the key number of the part, from the PART LIST on page
22. The second number refers to the quantity used in assembly. Note; Some small parts may have been pre-
assembled for shipping. If a part is not in the parts bag, check to see if it has been pre-assembled.
Note: If a part is not in the parts bag, first check to see if it has been pre-assembled. If a part is missing,
call toll-free 1-800-999-3756.
0
M6 Flat M8 Nylon M10 Zinc Split M10 Black Nylon M10 Zinc Nylon
Washer (71)-1 Locknut (61)-4 Washer (85)-2 Locknut (63)-2 Locknut (66)-2
1/2" Nylon
Locknut (52)-1
M4 x 16mm M4 x 22mm
Screw (73)-6 Screw (91)-2
M6 x 16mm
Screw (64)-5
M6 x 25.4mm Button
Screw (79)-1
M6 x 50mm Screw (69)-1
M8 x 14mm Button
Screw (88)-1
M8 x 39mm Button
Bolt (76)-2
M8 x 12ram Button
Screw (94)-4
M10 x 52mm Zinc Button
Bolt (68)-2
M10 x 45mm Button
Screw (74)-2
M1Ox 112mm Carriage Bolt (65)-2
"x 70mm Button Bolt (51)-1
4