Table of Contents
Advertisement
ASSEMBLY
Assembly requires two people. Place all parts of the exercise cycle in a cleared area and remove the packing
materials. Do not dispose of the packing materials until assembly is completed. Read through all steps before
beginning. During assembly, make sure that all parts are oriented as shown in the drawings.
Assembly requires the included tool and grease packet as well as an adjustable wrench
a rubber mallet
Use the drawings below to identify the small hardware used in assembly. The number in parenthesis beneath
each part refers to the key number of the part, from the PART LIST on page 10. The second number refers to
the quantity used in assembly. Note: some of the hardware shown below may have been pre-attached.
M8 Spring Washer (3)Ð4
M8 Washer (5)-4
M6 x 16 Screw (49)-8
3/16Ó Small Screw (2)Ð15
1. Press an Endcap (40) onto each of the Frame Extensions (65).
Press the Frame Extensions (65) into the Frame (1) as shown.
, and a phillips screwdriver
M8 Locknut (32)-8
1/2" Locknut (23)-2
Link Arm Bushing (47)-2
M6 x 9mm Screw (66)-1
.
3/8" Push Cap (19)-2
5/8" Push Cap (35)-2
Pedal Bushing (25)-2
1
40
4
65
1
65
40
,
Advertisement
Table of Contents
