Table of Contents
Advertisement
8612 and 8614 Router QSG
Supplying Power to the Device
The SDG-8612 and SDG-8614 comes with a region specific AC to USB-C power adapter. Available regions include: North America, United
Kingdom, EU, and Australia/New Zealand.
g
NOTE
3rd party USB-C power supplies are not recommended for use as they may not provide the required USB power delivery profile for the
SDG-8612 and SDG-8614 units.
Power is supplied to the SDG-8612 and SDG-8614 via a USB-C power input connector located on the bottom of the SDG (see
Routing Hole for
Power Cable
Console Port
(shown here without rubber flap
cover)
1. Connect the USB-C end of the power adapter to the USB-C Power In Port on the bottom of the device.
2. Plug the other end of the power adapter into the wall outlet.
3. The SDG will begin powering up immediately as the SDG-8612 and SDG-8614 have no on/off power switch.
4. Confirm that the power is connected properly by checking the Power LED located to the right of the Power In port.
LED
Color
Green
Power
Red
Off
5. The Multifunction Status LED should be lit on the front of the device, as described in the following section
Subscriber Connections
The following subscriber connections are available on the SDG-8612 and SDG-8614:
■ 2.5G Ethernet interface (RJ-45 connector) - WAN port (SDG-8612 only)
■ SFP+ cage - WAN port (SDG-8614 only). Maximum power output capability is 2.7W.
■ 2.5G Ethernet interface (RJ-45 connector) - LAN port
■ 3x Ethernet port (RJ-45 connector) – LAN port
■ USB 3.0 (Type A Connector)
To connect the Ethernet interfaces, refer to
8612 and any LAN port until there is an audible click.
To install a SFP+ into the SDG-8614, complete the following steps:
g
NOTE
Only CDRH certified laser class I (1) optical transceivers must be used when connecting an optical transceiver to the SFP+ cage. Do not
remove the protective dust cover from the SFP+ until the fiber optic cable is ready to be connected.
1. Insert the SFP+ into the SFP+ cage on the device.
2. Slide the SFP+ all the way into the SFP+cage until there is an audible click.
The USB 3.0 host port is reserved for future use. This port currently provides +5 VDC for charging external devices.
6SDG861214-13A
Figure 2. SDG-8612 and SDG-8614 Bottom View
State
Description
Correct Power
Solid
Incorrect Power
No Power
Figure 1
on page 1 and insert a Category 5E (or better) RJ-45 cable into The WAN port on the SDG-
Installing the SDG-8612 and SDG-8614 Router
USB-C Power In Port
Power LED
"Multifunction Status
Figure
2).
LED".
3
Advertisement
Table of Contents
