Wieland SIN 1 Series Installation Instructions Manual page 9

Installation instruction (translation from original)
SIN 1 xxx / SIN 2 xxx
Safety switch with separate actuator and guard lock
2.1 Aligning actuator head
1. Choose approach direction.
*
1
* Remove screw together with actuator head for both directions of rotation.
2. Turn head: 4 × 90°
1
3. Anti-tampering device.
Exceeding the maximum torque of 0.9 Nm or fitting the actuator in such a
way as to cause shearing force may irreparably damage the actuator on
⇒ Loss of personal protection function!
the switching device.
2
1
* Replace screw with actuator head for both directions of rotation by the one-way screw supplied with the switch.
2.2 Securing the switch / actuator
The mounting surface must be flat (even).
1. Secure switching device that it is positively locked (see 3 Actuators and dimension).
2. Fit actuator such that the molded end of the actuator is flush with the edge of the enclosure (see "STOP" mark in illustrations in 3 Ac-
tuators and dimension).
3. Align actuator with the safety guard such that shearing forces cannot affect the actuator head even after repeated opening/closing.
4. Permanently attach the actuator to the safety guard with a rivet or one-way screws.
Doc. # BA000776 – 06/2023 (Rev. C)
R1.310.xxx.x
2
2
CA UTION
NOT E
Wieland Electric GmbH
Brennerstraße 10 – 14
96052 Bamberg
Phone +49 951 9324-0
Fax +49 951 9324-198
info@wieland-electric.com
www.wieland-electric.com
3
3
SIN 1 xxx / SIN 2 xxx
Horizontal H
Horizontal H
Horizontal H
Vertical V
Vertical V
Vertical V
9 EN