Advertisement
Assembly
BEFORE FIRST USE
Remove any packaging material and
promotional labels.
When unpacking the hand mixer, check to see
you have received all the required parts before
discarding the packaging.
To release the hand mixer from the snap-on
storage case, pull outward on the corner of the
storage case where indicated at the opening,
while simultaneously pulling upwards and in
the opposite direction on the handle of the
hand mixer. (Fig. 1)
Remove the beaters, dough hooks & whisk
attachment from inside the storage case and
wash along with the storage case in warm
soapy water with a soft cloth. Rinse and dry
thoroughly.
Wipe the mixer motor body with a damp cloth
and dry.
8
WARNING
Never immerse the mixer motor body, power
cord or plug in water or any other liquid.
Ensure the hand mixer is switched off and
unplugged from the power outlet before fitting
the attachment/s to the mixer.
Incorrect insertion will result in the attachment
falling out during operation and may cause
damage.
Never use different attachments together as
this may damage your hand mixer.
NOTE
When first using the hand mixer, you may
notice an odour from the motor. This is normal
and will dissipate as the motor is run.
ASSEMBLY OF THE BEATERS & WHISK
NOTE
The beaters can be inserted into the sockets
interchangeably. The whisk can be inserted
into either socket.
1. Insert the beaters or whisk shafts into the
Fig. 1
attachment sockets.
2. Firmly push the beater or whisk into the
socket until it locks into place. Repeat for
the other beater.
NOTE
Always ensure the attachments are firmly
positioned before operating.
The dough hooks are NOT interchangeable
and must be inserted into the correct socket as
specified in this booklet.
Advertisement
