Advertisement
Functions
OPERATING YOUR BREVILLE HAND
MIXER
1. Ensure the speed control slider is set to the
OFF position.
2. Insert the appropriate attachment following
the previous instructions.
3. Select a mixing bowl large enough to
accommodate the chosen attachments,
as a bowl that is too small will damage
the attachments. Add the ingredients to
the mixing bowl as per the recipe or your
requirements.
4. Gently pull the power cord out of the motor
body.
5. Ensure the power cord is fully extended.
Plug the power cord into a 230V or 240V
power outlet and switch the power outlet on.
6. To commence mixing, slide the speed
control slider in a forward direction using
your thumb. Always begin mixing at a
lower speed setting to prevent splattering.
Increase the speed to suit the mixing task.
The speed setting can be adjusted during
operation by moving the speed control
slider forward and back between speeds 1
to 5.
7. Occasionally stop the hand mixer during
operation and scrape any food down the
sides of the mixing bowl with a spatula.
NOTE
Always slide the speed control slider to the
OFF position and place the hand mixer on the
bench if you need to scrape the bowl during
use, then continue mixing.
10
8. When mixing is complete, slide the speed
control slider to the OFF position. Switch
the hand mixer off at the power outlet and
remove the power plug from the outlet.
9. Sit the hand mixer upright on its heel on
a flat surface with the attachment/s facing
away from you. Remove the attachment/s
as previously explained. Use a spatula to
remove the mixture from the attachment/s.
Do not strike the attachment/s on the rim of
a mixing bowl.
WARNING
After mixing, remove the attachment/s with
care as they may be hot after use.
TURBO FUNCTION
Pressing the TURBO button while mixing
provides an extra boost of full power and
overrides the speed setting being used. Press
and hold the TURBO button for no more than
30 seconds at one time to avoid overheating.
RETRACTABLE CORD STORAGE
The hand mixer has a retractable cord for easy
power cord storage.
To safely retract the power cord, always
hold the plug with one hand and press the
retractable cord button with the other hand
to prevent the cord from striking any nearby
objects or persons. If the power cord gets
caught during retraction, release the button
and press it again until the cord is fully
retracted.
NOTE
Do not over-extend the power cord when
pulling out from the motor body as this may
cause damage to the power cord or damage the
retraction mechanism.
Advertisement
