Yamaha BANSHEE YFZ350M 1999 Owner's Manual page 128

Throttle cable adjustment
After the jet needle clip positions are
changed, throttle cable adjustment may be
necessary.
1. Move the throttle lever a few times.
2. Push the throttle lever forward until it
stops and hold it in this position.
3. Check through the window of each car-
buretor to see if the punch mark on the
throttle valve is at the specified posi-
tion.
a
0~1mm
( 0~0.04in )
a. Specified position
4. If not, loosen the locknuts and turn the
adjusters until proper position is
obtained.
q
1. Locknut (×2)
5. Move the throttle lever a few times and
recheck the position.
6. Install the fuel tank, side cover, radiator
cover and air filter case cover.
7. Reconnect the fuel hoses.
8. Install the seat.
8-23
w
2. Adjuster (×2)