Pioneer PL-3000/HB Service Manual page 11

e Auto-return position
1. If the tonearm returns too early, screw the PU
plate screw outwards (see Fig. 10).
2. If the tonearm returns too slow, screw the PU
plate screw inwards.
Feed plate
PU plate screw
Fig. 10
@ Tonearm misoperation
If the tonearm should happen to stop midway
during the lead-in operation, adjust the nut shown
in Fig. 11.
Note:
This nut should be neither too tight, nor too loose.
Operation plate.
12
e Short switch
The short switch gap should be 0.5mm during
record play. This gap may be adjusted by the
screw shown in Fig. 12 below.
—
Fig. 12