Terrco 6200 Operating Instructions, Maintenance Instructions, Spare Part List page 5

MODEL 6200
OPERATING AND MAINTENANCE INSTRUCTIONS
INTRODUCTION
This Manual has been prepared to assist you in the proper maintenance and operation of your Terrco® Machine. Please
bear in mind that your Terrco® 6200 is a precise piece of machinery manufactured to exacting standards. In order for you
to obtain maximum use of your Terrco® 6200, we suggest that you read this manual completely and thoroughly before
attempting to operate your machine. A parts diagram and parts list are included to assist you in ordering the proper
parts. Always give the machine number and model number when ordering your repair parts.
PRELIMINARY PROCEDURES TO FOLLOW BEFORE OPERATING MACHINE FOR THE FIRST TIME:
DELIVERY OF MACHINE
1. On delivery the contractor should very carefully examine the shipping crate to see that it has not been mishandled.
Before accepting the shipment, uncrate the machine and very carefully examine the machine to ensure that nothing
has been damaged. If damage is noted, request an inspection immediately and request a copy of the claim report. When
accepting the machine from the delivery carrier, note the damage on the bill of lading before signing.
2. Terrco® WILL NOT honor any claims for broken, damaged, or missing parts that may have occurred in shipping, as
each machine is checked and inspected before leaving our plant.
The machine has been fully lubricated at the factory before shipping.
ON-THE-JOB INSTRUCTIONS
INSTALLATION INSTRUCTIONS-STONES
1. Move the counterbalancing weights to the upper weight baskets.
2. Tilt the machine back so that the caster wheel rests on the oor.
3. Clean mounting surface both on plug stone and stone holder. On 2" or 3" diameter plug stone, push stone in the hole
and give the stone a slight twist to be certain it is securely in place.
4. Grasp machine handle and lower the machine slowly to the oor. Make certain no stones have fallen or loosened
while lowering the machine.
5. Return the counterbalancing weights to the lower weight baskets.
TRANSPORTING THE MACHINE
1. With the counterbalancing weights in the upper weight baskets, tilt the machine so that the caster wheel is rmly on
the oor. You can push from the gearcase side or use the op handle to pull.
TO OPERATE THE MACHINE
1. Disconnect the electrical source.
2. Install the stones per instructions in installation section.
3. After stones are installed, lower the machine until it is in operating position.
CAUTION! - Never attempt to start the machine while lowering it to the oor, as rear stones will strike on corners
resulting in thrown stones and possible damage to the machine and/or oor surface.
4. Before pluggins into the electrical system, check the voltage at the source. The minimum acceptable voltage is
(210/420 Volt, 60 HZ, 3 phase), or (380 Volt, 50 HZ, 3 phase). Anything lower than this can result in blown heaters and
possible motor burnout.
5. If the machine is to operate in an area more than 200 feet from the source, it will be necessary to use the next larger
size cable than the cable that was furnished with the machine.